IIT-JEE 2007 Paper 1 Offline
JEE Advanced / 66 questions
2026Sun, Apr 8, 2007 3:30 AM66 PYQs
1Dual Nature Of Radiation
Statement 1 :
If the accelerating potential in an X-ray tube is increased, the wavelengths of the characteristic X-rays do not change.
Statement 2 :
When an electron beam strikes the target in an X-ray tube, part of the kinetic energy is c...
If the accelerating potential in an X-ray tube is increased, the wavelengths of the characteristic X-rays do not change.
Statement 2 :
When an electron beam strikes the target in an X-ray tube, part of the kinetic energy is c...
MCQ+3 / -12007
2Electrostatics
A long, hollow conducting cylinder is kept coaxially inside another long, hollow conducting cylinder of larger radius. Both the cylinder are initially electrically neutral.
MCQ+3 / -12007
3Electrostatics
Consider a neutral conducting sphere. A positive point charge is placed outside the sphere. The net charge on the sphere is then,
MCQ+3 / -12007
4Geometrical Optics
In an experiment to determine the focal length (f) of a concave mirror by the u-v method, a student places the object pin A on the principal axis at a distance x form the pole P. The student looks at the pin and its inverted image form a di...
MCQ+3 / -12007
5Geometrical Optics
A ray of light travelling in water in incident on its surface open to air. The angle of incidence is \(\theta\), which is less than the critical angle. Then there will be
MCQ+3 / -12007
6Geometrical Optics
Statement 1 :
The formula connecting u, v and f for a spherical mirror is valid only for mirrors whose sizes are very small compared to their radii of curvature.
Statement 2 :
Laws of reflection are strictly valid for plane surfaces, but no...
The formula connecting u, v and f for a spherical mirror is valid only for mirrors whose sizes are very small compared to their radii of curvature.
Statement 2 :
Laws of reflection are strictly valid for plane surfaces, but no...
MCQ+3 / -12007
7Gravitation
Some physical quantities are given in Column I and some possible SI units in which these quantities may be expressed are given in Column II. Match the physical quantities in Column I with the units in Column II and indicate your answer by d...
MCQ+3 / -12007
8Heat And Thermodynamics
The piston is now pulled out slowly and held at a distance 2L from the top. The pressure in the cylinder between its top and the piston will then be
MCQ+3 / -12007
9Heat And Thermodynamics
The piston is taken completely out of the cylinder. The hole at the top is sealed. A water tank is brought below the cylinder and put in a position so that the water surface in the tank is at the same level as the top of the cylinder as sho...
MCQ+3 / -12007
10Impulse And Momentum
Statement 1 :
In an elastic collision between two bodies, the relative speed of the bodies after collision is equal to the relative speed before the collision.
Statement 2 :
In an elastic collision, the linear momentum of the system is cons...
In an elastic collision between two bodies, the relative speed of the bodies after collision is equal to the relative speed before the collision.
Statement 2 :
In an elastic collision, the linear momentum of the system is cons...
MCQ+3 / -12007
11Laws Of Motion
Two particles of mass m each are tied at the ends of a light string of length 2a. The whole system is kept on a frictionless horizontal surface with the string held tight so that each mass is at a distance 'a' form the centre P (as shown in...
MCQ+3 / -12007
12Motion
While the piston is at a distance 2L from the top, the hole at the top is sealed. The piston is then released, to a position where it can stay in equilibrium. In this condition, the distance of the piston from the top is :
MCQ+3 / -12007
13Rotational Motion
The ratio \({{{x_1}} \over {{x_2}}}\) is
MCQ+3 / -12007
14Rotational Motion
When disc B is brought in contact with disc A, they acquire a common angular velocity in time t. The average frictional torque on one disc by the other during this period is
MCQ+3 / -12007
15Rotational Motion
The loss of kinetic energy during the above process is :
MCQ+3 / -12007
16Work Power And Energy
Statement 1 :
A block of mass m starts moving on a rough horizontal surface with a velocity v. It stops due to friction between the block and the surface after moving through a certain distance. The surface is now tilted to an angle of 30$$...
A block of mass m starts moving on a rough horizontal surface with a velocity v. It stops due to friction between the block and the surface after moving through a certain distance. The surface is now tilted to an angle of 30$$...
MCQ+3 / -12007
