JEE Advanced
Laws Of Motion PYQJEE Advanced 2020 Paper 1 Offline
INTEGER+4 / -02020
Put a uniform meter scale horizontally on your extended index fingers with the left one at 0.00 cm
and the right one at 90.00 cm. When you attempt to move both the fingers slowly towards the center,
initially only the left finger slips with respect to the scale and the right finger does not. After some
distance, the left finger stops and the right one starts slipping. Then the right finger stops at a distance
xR from the center (50.00 cm) of the scale and the left one starts slipping again. This happens
because of the difference in the frictional forces on the two fingers. If the coefficients of static and
dynamic friction between the fingers and the scale are 0.40 and 0.32, respectively, the value of xR (in
cm) is ______.
and the right one at 90.00 cm. When you attempt to move both the fingers slowly towards the center,
initially only the left finger slips with respect to the scale and the right finger does not. After some
distance, the left finger stops and the right one starts slipping. Then the right finger stops at a distance
xR from the center (50.00 cm) of the scale and the left one starts slipping again. This happens
because of the difference in the frictional forces on the two fingers. If the coefficients of static and
dynamic friction between the fingers and the scale are 0.40 and 0.32, respectively, the value of xR (in
cm) is ______.
Solution
Answer: 25.60
Use the Friction Switch Condition
When the slipping shifts from one finger to the other, limiting static friction on one side balances kinetic friction on the slipping side:
Relate Normal Reactions by Torque
Taking moments as in the given setup,
Find the First Distance
Combining the two relations,
Apply the Next Switching Relation
For the next change of slipping finger, use the corresponding friction and torque ratio from the source setup:
